19. Click Program Scan to start
the scanning process. If you
want to terminate the searching
process, just click Stop.
If you have set up the
motor/dish position, when you
click Program Scan, a
message pops up notifying you
the motor is adjusting position.
Channel scanning only begins
as soon as the countdown time
is up or you click Continue. It is
recommended NOT to
click Continue but wait until the
countdown time is up in case of
channel scanning failure due to
invalid positioning.
20. You can check the scanning
progress from the progress bar.
After scanning, the active TV
channels will be listed inside
the box. Click Apply to save
the scanned channels.
To Next Page
Loading...