Downloading a Script
Follow these instructions to download a script from the MS DOS prompt. Set
the communication parameters using the MODE command. Then, prepare
the printer to accept a script.
1. From the printer's Script Menu, press » or ¼ until you see
SCRIPTS
Load Script ¼
2. Press Enter/Pause.
Script Load
Ready
Note: Only one script can be loaded in the printer at a time.
When downloading a script, if you receive an error:
♦ Check the available flash memory. See "Checking Available Flash
Memory" in Chapter 6 for more information.
♦ Format flash memory. See "Formatting Flash Memory" in Chapter 6 for
more information.
After downloading a script, if the script does not appear to be loaded, try
formatting flash memory and download the script again.
Using Scripts 7-3
To Next Page
Loading...
