Initial Script Startup Procedures
Before you can start using a script, check the following items:
♦ Check to see if a script is already loaded in the printer. See "Viewing
Script Information" to continue.
♦ Format flash memory, if needed. See "Formatting Flash Memory" in
Chapter 6 for more information.
♦ Download a script to the printer, if needed. See "Downloading a Script"
to continue.
Viewing Script Information
1. To see if your printer has a script loaded from the Main menu, press
» or ¼ until you see
MAIN MENU
» Scripts ¼
2. Press Enter/Pause. If password protection in enabled, press Feed/Cut
three times, then press Enter/Pause before you see the Scripts Menu
options.
3. Press » or ¼until you see
SCRIPTS
» Script Info ¼
4. Press Enter/Pause. What you see depends on the script. If a script is
not loaded, you see "No script loaded." If a script is loaded, you see the
script name and version number, for example,
MYSTORE
Version 1.0
If a script is already loaded, see "Enabling a Script," to continue. If
you need to download a script, see "Formatting Flash Memory
" in
Chapter 6.
7-2 Operator's Handbook
To Next Page
Loading...
