Avery Dennison Monarch 9825 - Setting the Stop Bits; Setting the Parity

Setting the Stop Bits
To change the setting, from the Main Menu select Setup, Port Settings, then
Serial Comm. Then, follow these steps.
1. Press » or ¼ until you see
SERIAL COMM
» Stopbits ¼
2. Press Enter/Pause. The current setting is displayed, for example:
STOPBITS
1 ¼
3. Press » or ¼ to display the number of stop bits you need, then press
Enter/Pause. Press Escape/Clear until you see the Main Menu.
Setting the Parity
To change the setting, from the Main Menu select Setup, Port Settings, then
Serial Comm. Then, follow these steps.
1. Press » or ¼ until you see
SERIAL COMM
» Parity ¼
2. Press Enter/Pause. The current setting is displayed, for example:
PARITY
None ¼
3. Press » or ¼ to display the parity you need, then press Enter/Pause.
Press Escape/Clear until you see the Main Menu.
Setting Communications 5-3