5. Close the printer's cover.
6. Press Feed/Cut to position the supply under the printhead.
Using the Optional Tear Bar
Note the following change to loading labels if you have purchased the
optional tear bar. Tear labels against the tear bar. You cannot tear tags
with the tear bar.
Slide the supply between the tear bar and peel bar. It may be easier if you
cut or fold one corner of the supply first.
Tear Bar
Peel Bar
Note: Do not tear both label and backing paper at the same time.
♦ Tear labels against the tear bar.
♦ Tear backing paper against the tear edge.
Backing Paper
Tear Edge
2-8 Operator's Handbook
To Next Page
Loading...
