9
CARE & MAINTENANCE
This chapter tells you how to
♦ clear label jams and clean the printer.
♦ replace a printhead.
CAUTION: Do not use sharp objects to clean the printhead or touch the
printhead with your fingers. This may damage the printer and
require a service charge.
Clearing Label Jams
When you are printing and a jam occurs, the Fault light on the printer's front
panel blinks. To clear the jam:
1. Turn off the printer and open the cover and printhead assembly.
2. If necessary, remove the label roll and ribbon.
3. Remove the jammed labels and reload the label roll.
4. Close the printhead assembly and turn on the printer.
5. Press Feed/Cut to position the supply under the printhead.
Cleaning
The rate and frequency at which you print determines how often you must
clean the printer.
Note: You must clean the printhead as described below to maintain
printhead life.
Care & Maintenance 9-1
To Next Page
Loading...
