Chapter 8: Completing the Hardware Assembly 69
5 Take the Master Compression Panel (included in the Side Covers package) and hold it so that the side with the springs faces the
back of the frame. If you have a Frame Chassis Small, use the smaller Master Compression Panel.
6 Holding the panel at an angle, place the spring side of the panel against the back of the chassis. Apply enough pressure to com-
press the springs, then lower the front edge and snap it into place.
Installing T-Strips
After installing modules and Compression Panels, install T-strips to further secure the modules in their chassis.
To install T-Strips:
1 Collect all T-strips: One is included with each Frame Chassis kit and one is included with the Side Covers kit. In addition, the
Producers Desk includes a special two-piece T-strip.
2 Take a full length T-strip and, orienting it as shown in Figure 49, do the following for each channel and master section chassis:
• Insert the bottom end (the end closest to the front of the control surface) into the receiving slot in the Side Wall.
• Working towards the back, push the T-strip down into its channel then push the end of the T-strip down so it clicks into place.
3 Repeat for all other full length T-strips.
Figure 48. Installing a Master section Compression Panel
Figure 49. Installing a T-strip
2
1
1
2
To Next Page
Loading...
Need help?
General
