IFD400 Series Pilot Guide
6-40 General
IFD Glove Qualification Procedure
Touch the standby frequency window
and verify a virtual keyboard is
displayed. †
Type 121.7, press the "ENTER" button
on the virtual keyboard and confirm
121.700 is the displayed frequency in
the standby Com window. †
Press each of the page tabs displayed
on the present page and verify the IFD
changes to the selected tab.
With the FMS FPL tab displayed, use
touch to type in a typical flight plan and
verify that all entries were recognized.
With the Map page and tab displayed,
attempt to pan the map.
With the Map page and tab displayed,
attempt to pinch zoom (in or out) the
map to produce a range change.
With the Map page and tab displayed,
attempt to graphically flight plan ("rubber
band") and verify the intended change
was made.
Press the "Freq" key on the bezel and
then double tap a frequency from the list
to place it into the standby slot. †
To Next Page
Loading...
