IFD400 Series Pilot Guide
System Overview 1-29
DIRECT-TO OPERATIONS
A dedicated Direct-To key is located along the right edge of the
IFD bezel. Pressing that button from any page will display a
green Direct-To dialog box that will be pre-populated with a
logical waypoint.
Direct-To Dialog and Confirmation Dialog Boxes
If that pre-populated waypoint is the desired waypoint, press the
“ENTR” key along the right edge of the bezel twice (Direct-To,
Enter, Enter) or touch the Activate dialog box that pops up on the
display to accept.
If a different waypoint is desired, there are a number of ways in
which the proper waypoint can be entered in that Direct-To dialog
box:
Turn the bottom right outer knob to populate the dialog
box with by scrolling through the waypoints in the flight
plan. This technique will only include waypoints within a
missed approach if the missed approach is enabled.
When the desired waypoint is displayed, press the knob
button or ENTR key to accept
Touch the waypoint field in the dialog box to generate a
virtual keyboard and then use the keyboard to enter the
desired waypoint identifier. It may not be necessary to
enter every character, since the field is managed by
To Next Page
Loading...
