IFD400 Series Pilot Guide
General 6-39
USE OF GLOVES
Many types of gloves can be used with the IFD touch screen
display. The key parameter for the effectiveness of a glove with
touch screen is the distance between the finger and the glass and
to a lesser extent, the type of material separating the skin from
the glass. The thinner the glove or the more compatible the
material (e.g. leather, fine cotton, etc), the greater the likelihood
of success will be. Likewise, the more surface area that comes in
contact with the glass, the greater the success may be. Each
glove must be qualified for compatibility with the display and
those glove calibration procedures (specific to the glove and the
pilot combination) are immediately below. If all test steps are
marked as a “Pass” then the glove/pilot combination is
considered to be a qualified pair.
To Next Page
Loading...
