To Next Page

To Previous Page

System Lockout

Indicates a Non-Operating Lockout Condition, for example unmapped input connected to 24 V.

7.10 Virtual Status Outputs

Up to 64 Virtual Status Outputs can be added for any conﬁguration using Modbus/TCP, EtherNet/IP Input Assemblies,

EtherNet/IP Explicit Messages, and PCCC protocols on FID 1 Base Controllers and up to 256 virtual Status Outputs can be

added on FID 2 Base Controllers and SC10-2 Safety Controllers. FID 2 Base Controllers and SC10-2 Safety Controllers can

also use PROFINET. These outputs can communicate the same information as the Status Outputs over the network. See

Status Output Functionality

on page 60 for more information. The Auto Conﬁgure function, located on the Industrial

Ethernet tab of the Software, automatically conﬁgures the Virtual Status Outputs to a set of commonly used functions,

based on the current conﬁguration. This function is best used after the conﬁguration has been determined. Virtual Status

Output conﬁguration can be manually revised after the Auto Conﬁgure function has been used. The information available

over the network is consistent with the logical state of the inputs and outputs within 100 ms for the Virtual Status Output

tables (viewable via the Software) and within 1 second for the other tables. The logical state of inputs and outputs is

determined after all internal debounce and testing is complete. See

Industrial Ethernet Tab

on page 102 for details on

conﬁguring Virtual Status Outputs.

XS/SC26-2 and SC10-2 Safety Controllers

Banner SC10-2roe User Manual

Questions and Answers: