Barco G62 Series - Page 70

R5914654 /04 G62 series70
1
2
Image 4–18
9. Mount a safety cable through the eye on the safety bar.
Slide the safety cable through the eye (reference 1 on Image 4–19) on the safety bar (reference 2 on
Image 4–19) and then through the loop end at the beginning of the cable (reference 1 on Image 4–19).
Install a U-bolt near to the safety eye (reference 3 on Image 4–19). Make sure that both a part of the loop
end and the outgoing part of the safety cable are placed in the enclosure.
Close the U-bolt and tighten it.
2
1
3
3
Image 4–19
10. Place the shackle through the free loop end of the safety cable.
Connect the shackle on the truss or rigging frame. If necessary before connecting the shackle turn the
cable a few times around the truss or rigging frame so the play is at a minimum.
If it is not possible to the truss or rigging frame, mount it to the lens support. Turn it a few times around the
support so the play is at a minimum and hook the shackle on the cable.
Image 4–20
UST lens R9801830 G lens (0.37 - 0.40 : 1) UST 90°