Basler pilot User Manual

Features
164 Basler pilot
Setting the AOI
By default, the AOI is set to use the full resolution of the camera’s sensor. You can change the size
and the position of the AOI by changing the value of the camera’s X Offset, Y Offset, Width, and
Height parameters.
 The value of the X Offset parameter determines the starting column for the area of interest.
 The value of the Y Offset parameter determines the starting line for the area of interest.
 The value of the Width parameter determines the width of the area of interest.
 The value of the Height parameter determines the height of the area of interest.
When you are setting the camera’s area of interest, you must follow these guidelines on all camera
models:
 The sum of the X Offset setting plus the Width setting must not exceed the width of the
camera’s sensor. For example, on the piA640-210gm, the sum of the X Offset setting plus the
Width setting must not exceed 648.
 The sum of the Y Offset setting plus the Height setting must not exceed the height of the
camera’s sensor. For example, on the piA640-210gm, the sum of the Y Offset setting plus the
Height setting must not exceed 488.
On monochrome cameras:
 The X Offset, Y Offset, Width, and Height parameters can be set in increments of 1.
On color cameras:
 The X Offset, Y Offset, Width, and Height parameters can be set in increments of 2 and they
must be set to an even number. For example, the X Offset parameter can be set to 0, 2, 4, 6, 8,
etc.
Note
Normally, the X Offset, Y Offset, Width, and Height parameter settings refer to
the physical columns and lines in the sensor. But if binning is enabled, these
parameters are set in terms of "virtual" columns and lines. For more
information, see Section 11.6 on page 163.

Basler pilot Specifications

General

Brand	Basler
Model	pilot
Category	Security Camera
Language	English