Software and Hardware Installation
Basler pilot 27
2 Software and Hardware
Installation
The information you will need to install and operate the camera is included in the Installation and
Setup Guide for Cameras Used with Basler’s pylon API (AW000611xx000).
You can download the Installation and Setup Guide for Cameras Used with Basler’s pylon API from
the Basler website: www.baslerweb.com/indizes/download_index_en_19627.html.
The guide includes the information you will need to install both hardware and software and to begin
capturing images. It also describes the recommended network adapters, describes the
recommended architecture for the network to which your camera is attached, and deals with the IP
configuration of your camera and network adapter.
After completing your camera installation, refer to the "Basler Network Drivers and Parameters" and
"Network Related Camera Parameters and Managing Bandwidth" sections of this camera User’s
Manual for information about improving your camera’s performance in a network and about using
multiple cameras.
To Next Page
Loading...
Need help?
General
