Features
Basler pilot 169
Binning’s Effect on the Sensor Readout and Frame Rate Formulas
In several areas of the manual, formulas appear for sensor readout time and for calculating the
maximum frame rate. In several of these formulas, you must enter the current height of the area of
interest (AOI). If you are not using binning, you would enter the height of the AOI in physical sensor
lines. If binning is enabled, however, you must use the concept of a "virtual" sensor as described
above and the height of the AOI that you use in the formulas would be in terms of virtual sensor
lines.
The affected formulas appear on page 100 and on page 103.
To Next Page
Loading...
