BG 25 / 2011 / 2254_BG25_en_0000498763_V01
B00005424.png
There is a jaw (16) in front of the rope sheave to facilitate mounting of
the wedge.
Insert the rope into the jaw (16), pre-tension it manually and screw the jaw (16) into
place. Once the wedge (15) has been mounted, remove the jaw (16) from the rope
tensioning cylinder again.
Thread the rope through the wedge (15) (ensuring the other wedge (13) is securely
in place) and attach it with bolts to the rope tensioning cylinder.
Attach the rope clip (14) to the rope end at a distance of approx. 20 mm from the
wedge (15).
Reduce the length of the overhanging rope to approx. 30 cm.
Slightly tension the ropes by retracting the rope tensioning cylinder.
To Next Page
Loading...
