Baumuller b maXX 1000 - Page 34

Parameter description
Parameter manual b maXX
®
1000
Document no. 5.07004.03 Baumüller Nürnberg GmbH
34
of 208
4.3
P0122
If temperature exceeds the motor PTC overheat warning level ZP0120–, the drive will act
according to ZP0122– and display error code 0512
hex
. If the temperature decreases be-
low the result (ZP0120– minus ZP0121–), the warning display will disappear.
P0123
P0124
Parameters ZP0057–, ZP0061–, ZP0065– and ZP0111– can only be changed if
ZP0124– = 0.
P0122
Motorüberhitzung Warnung 0 to 2
EE Motor PTC overheat warning protection 0
STOP BM_u_PTCOverheatWarning 1:1 -
Value Meaning
0 Warn and RAMP to stop
1 Warn and COAST to stop
2 Warn and keep running
P0123
Motor Nenndrehzahl/Nennfrequenz Auswahl 0 to 1
EE Motor rated speed/nominal slip master selection 1
STOP BM_u_MotorRatedSpeedSlipSelection 1:1 -
Value Meaning
0 Motor rated speed is existing, motor rated Slip can automatic calculation with ZP0124–
1 Motor rated slip is existing, motor rated speed can automatic calculation with ZP0124–
P0124
Motor Nenndrehzahl/Nennfrequenz Bestätigung 0 to 2
EE Motor rated speed/nominal slip master selection
confirm
0
STOP BM_u_MotorRatedSpeedSlipSelectionConfirm 1:1 -
Value Meaning
0 Motor nominal slip frequency or motor rated speed can be changed
1 Start calculation
2 Calculated motor nominal slip frequency or motor rated speed OK