Parameter description
Parameter manual b maXX
®
1000
Document no. 5.07004.03 Baumüller Nürnberg GmbH
96
of 208
4.3
P1126
The parameter are used to set the analog input reference values and is based on percent-
age of ZP0033–). For further information see ZFigure 44– and ZFigure 45– on page 95.
P1127
Please note the ACI/AVI switch on the b maXX
®
1000.
For further information see ZFigure 44– and ZFigure 45– on page 95.
P1128
The parameter are used to set the analog input reference values and is based on percent-
age of ZP0033–). For further information see ZFigure 44– and ZFigure 45– on page 95.
P1129
Please note the ACI/AVI2 switch on the b maXX
®
1000. Switch to ACI for 4 to 20 mA an-
alog current signal (ACI) (ZP1129– should be set to 0) and AVI2 for analog voltage signal
(AVI2) ((ZP1129– should be set to 1).
Figure 46: ACI/AVI2 selection
This parameter selects between ACI and AVI2.
P1126
Minimale AVI Frequenz 0.0 to 100.0 %
EE Minimum AVI frequency 0.0 %
STOP BM_u_MinimumAVIFrequency 10:1
P1127
Maximale AVI Spannung 0.0 to 10.0 V
EE Maximum AVI voltage 0.1 V
STOP BM_u_MaximumAVIVoltage 10:1
P1128
Maximale AVI Frequenz 0.0 to 100.0 %
EE Maximum AVI frequency 0.0 %
STOP BM_u_MaximumAVIFrequency 10:1
P1129
ACI/AVI2 Auswahl 0 to 65535
EE ACI/AVI2 selection 0
STOP BM_u_ACIAVI2Selection 1:1
Value Meaning
0 ACI
1 AVI2
To Next Page
Loading...