119
Sun protection
Drives
4. Programming the unlocking
limit position
Run the shading solution down out
of the locking position until the
locking mechanism clicks . Then
press the programming button on
the programming unit until the
drive clicks once .
3. Moving the shading solution
into the locking mechanism
Run the shading solution up into the
locking mechanism until the drive
switches off automatically.
Click
5. Deleting the limit positions
using the programming unit
- Press and hold the programming
button
- Press and hold the button
-
Release the programming button
- Press the programming button
again until the drive clicks twice.
If the drive is situated between the
limit positions, both limit positions
are deleted. If the drive is situated
in one of the limit positions, only this
position will be deleted.
1x click
To Next Page
Loading...
Need help?
General