Becker M - VC470-II Control Unit

146
Commissioning
Wiring
The external radio receiver VC470-II
can be used to convert conventional
drives for venetian blinds, awnings
and roller shutters to radio drives.
The Hirschmann STAS 3 connector
is used as the connection at the drive
and the Hirschmann STAK 3 cou
-
pling is used as the connection to the
mains supply.
Mains
Mains
Drive
Drive
VC470-II control unit
2. Correcting the direction of
rotation
Carefully turn the reversing switch
on the mains connection side of the
VC470-II to the opposite position to
reverse the direction of rotation.
1. Programming the master
transmitter
Switch off the power supply on the
VC470-II radio receiver and then
switch it back on . Then press the
programming button on the master
transmitter until the control unit
shifts briefly to confirm the program-
ming operation (3 seconds for initial
installation, 10 seconds to overwrite
a previously programmed master
transmitter).