To Next Page

To Previous Page

General

All other drives can be identified via the programming

unit. Connect the wires in the connecting cable of

the drive to the wires of the same colour in the

programming unit.

Press the programming button

for 2 seconds.

If the drive produces a loud noise and the tube does not

turn, the drive is a type M. Replace the programming

unit immediately with one that is suitable for an M drive.

If the drive does not react or clicks once or twice, it is

an S(+), PS(+), SEB(+), SE I1, SEF I1, SF(+), PSF(+),

C12 or C18 drive type.

Press the travel button to move in both directions.

Which type of sun protection drive has been installed?

The limit positions of the latest generation of drives with

electronic limit switching can be deleted and redefined

via the existing control panel. To do this, proceed as

follows:

First, run the drive for 6 seconds in the Retract or

Extend direction.

Then perform the travel movements described oppo-

site to delete the limit positions. If the drive then clicks

twice, it is one of the following types: E18, E12 or E15.

If the drive is installed in a zip screen, it is an E18 type

drive.

To identify the types E12 and E15, move the drive in

any direction.

If the drive stops after roughly 3 seconds then continues

running, it is an E15 type drive.

If the drive stops after roughly 10 seconds then continues

running it is an E12 type drive.

1 s

5 s

Deleting the limit positions

Becker M User Manual

Questions and Answers: