Becker M - SWS441;SWS641 Control Set

142
1. Programming the master
transmitter
Switch off the power supply on the
radio receiver (drive type PSF(+))
and then switch it back on . Press
the programming button on the
master transmitter until the drive
clicks twice .
Note: Follow the instructions on
pages 92 and 93 to set the limit
positions for the PSF(+) drive.
Commissioning the SWS441/SWS641 radio-controlled
Sun-Wind-Set hand-held transmitter with sensor
SWS441/SWS641 control set
2. Programming the SC811/
SC861
a) Press the programming button of
the master transmitter until the
tubular drive clicks once .
b) Then press the programming
button of the SC811/SC861
until the tubular drive clicks once
.
c) Press the programming button of
the SC811/SC861 again
until
the tubular drive clicks twice .
2x click
1x click
1x click
2x click