Becker M User Manual

125
Sun protection Drives
Programming the master
transmitter
Set the drive to programming mode
for 3 minutes by switching the power
on or by setting the radio switch
to the position . Then press the
programming button on the master
transmitter until the drive clicks
twice (3 seconds when installing
new drives, 10 seconds to overwrite
a previously programmed master
transmitter).
Correcting the direction of
rotation
If the drive is rotating in the wrong di-
rection, reverse the direction switch
on the drive.
Attention: The direction of rota-
tion can only be changed as long
as no limit positions have been
programmed.
Information
SEF I1 drives with electronic limit
switching detect and program the
Retract limit position automatically.
A fixed stop must be available in the
Retract limit position.
The shading solution is automatically
locked and tightened in the Extend
position.
Locking principle
The shading solution is extended
until the bolt has passed the locking
point (bolt clicks). The first point is
programmed here
.
Then run the shading solution in the
UP direction until the drive pulls the
fabric tight and switches off auto-
matically
.
The shading solution is then moved
out of the path of the locking
mechanism. A point is also
programmed here
.
Click Click
2x click

Becker M Specifications

General

Brand	Becker
Model	M
Category	DC Drives
Language	English