57
Roller shutter
Drives
Setting the intermediate positions
4. Programming the intermediate
position/ventilation position
Run the drive to the required intermediate
position/ventilation position and press
the STOP and DOWN buttons or STOP
and UP buttons until the drive clicks once.
To travel to the intermediate position/
ventilation position, press the DOWN
button or UP button twice within one
second (double tap).
Intermediate position Ventilation position
Note:
The drive moves in dead-man mode during the installation run (initial
opening and closing movement). The drive indicates the lack of a limit
position by briefly starting up, stopping and then continuing (limit position
status indicator). Once the limit positions have been detected correctly
3 times in succession (3 opening and closing movements), the drive
definitively saves the limit positions.
5. Deleting the intermediate
position/ventilation position
Run the drive to the position you wish to
delete and repeat the programming proce-
dure (press the STOP and DOWN buttons
or STOP and UP buttons) until the drive
clicks twice.
6. Activating the anti-freeze
mechanism at the top (optional)
Run the roller shutter towards the
upper stop. Then press the programming
button until the drive clicks once. Then
press the programming button, STOP
button and UP button until the drive
clicks three times.
Follow the same procedure to deactivate
the anti-freeze mechanism at the top.
1x click 1x click
1x click 3x click
To Next Page
Loading...
Need help?
General