89
Sun protection
Drives
Information
Stop behaviour
The E15 can be switched between
increased and reduced stop behav-
iour.
Increased stop behaviour with cassette awnings
Reduced stop behaviour with open awnings, screens,
etc.
Setting the limit positions
The limit positions can be set in
2 different ways:
. Programming unit
. Operator control unit
Setting the stop behaviour
On delivery, the 45 diameter and
58 diameter drive types have an in-
creased stop behaviour. The stop be-
haviour can only be changed during
the first 3 runs towards the upper stop.
Switching on reduced stop
behaviour
Move the shading solution in
the Retract direction
and
also press the programming
button before it reaches the
upper limit position . Keep
holding both buttons pressed
until the shading solution
confirms the changeover by
extending and retracting once .
Switching on increased stop
behaviour
Repeat the procedure under
until the drive confirms the
changeover by extending and
retracting twice .
To Next Page
Loading...
Need help?
General