AR6201 - RT6201 - RCU6201 - AR6203
Page 3-6 DV 14307.03 Issue 1 7/2013
To change the preset frequency
1. Press the “ROTARY ENCODER“ to select the 100 MHz digits. Then rotate the
“ROTARY ENCODER” clockwise/counter clockwise to change the frequency.
2. Press the “ROTARY ENCODER“ again to select the 100 kHz digits. Then
rotate the “ROTARY ENCODER” clockwise/counter clockwise to change the
frequency.
3. Press the “ROTARY ENCODER“ again to select the 25/8.33 kHz digits. Then
rotate the “ROTARY ENCODER” clockwise/counter clockwise to change the
frequency.
A short press of the “↨/SCN” key toggles between active and preset frequency.
Note: While the transceiver is in transmission mode, the toggle function
is disabled.
Press the “STO” key to store the active frequency into the next vacant memory
place in the user channels database.
3.5.2 Direct Tune Mode
Press the “MDE” key until the direct tune mode page appears.
Note: If BATTERY VOLTAGE in the installation setup is deselected, this mode
is
not
accessible! Only standard or channel mode are accessible.
In direct tune mode the active frequency is indicated in the top line. It can
be edited by means of the “ROTARY ENCODER” following the procedure. The
battery voltage, indicated in the bottom line shows the current value of the
supply voltage.
To Next Page
Loading...
Need help?
General
