AR6201 - RT6201 - RCU6201 - AR6203
DV 14307.03 Issue 1 7/2013 Page 3-7
To change the active frequency when in direct tune mode;
1. Press the “ROTARY ENCODER“ to select the 100 MHz digits. Then rotate the
“ROTARY ENCODER” clockwise/counter clockwise to change the frequency.
2. Press the “ROTARY ENCODER“, again to select the 100 kHz digits. Then rotate
the “ROTARY ENCODER” clockwise/counter clockwise to change the frequency.
3. Press the “ROTARY ENCODER“, again to select the 25/8.33 kHz digits. Then
rotate the “ROTARY ENCODER” clockwise/counter clockwise to change the
frequency.
Notes:
1. The changes become active immediately
2. Changing the active frequency is possible only when the transceiver is
not transmitting
If wanted press the “STO” key to store the active frequency into the next
vacant memory place in the user channels database.
3.5.3 Channel Mode
Note: The channel database provide storage of CH01 to CH99 and LAST1 to
LAST9.
Press the “MDE” key until the channel mode page appears.
The channel mode shows data from user channels database (indicated by “CH”),
or last channels database (indicated by “LAST”) and labels database on the
display.
After selecting channel mode, the active frequency remain indicated in the
top line. If this frequency has an already assigned channel number, channel
number and the text label appear in the bottom line of the display. If the
active frequency has no assigned channel number the indication in the bottom
line is “CH--”.
To Next Page
Loading...
Need help?
General
