6. Scope of warranty
Warranties regarding operational safety, reliability and performance will only be granted by the manufacturer if the device is used
according to the regulations and under the following conditions:
• Assembly, connection and maintenance are only carried out by authorized and qualified staff.
• The device is only used according to the operating and assembly manual.
• Never exceed or fall below the limit values as defined in the technical data.
• Modifications and repairs at the device may only be done by BEKA.
• The number of changed empty cartridges may not exceed 100.
However, the warranty is only excluded in the above-described conditions if the non-observance of the above-described conditions is
also the cause of the incurred damage.
The burden of proof for the missing causality of the damage lies with the buyer.
7. Transport and storage
Use suitable lifting devices for transport.
Do not throw the device or expose it to shocks.
Secure the device against toppling down or slipping during transport.
Observe all valid safety and accident prevention regulations for the transport. Wear suitable protective equipment if
necessary. Keep adequate distance to suspended loads. The transport help or the elevating device must have the
adequate carrying capacity.
When storing the device pay attention that the storage area is cool and dry in order to avoid corrosion of the
individual parts of the device.
Observe the storability of the lubricant contained in the cartridges. No longer use the cartridges if the lubricant
is over-stored (separation of oil and soap).
8. Assembly instructions
Check the device for possible transport damage and for completeness before the assembly. Any installed equipment for transportation
safety has to be removed.
Comply with the following conditions when assembling a complete machine from this device and other components.
Mind a proper and eco-friendly assembly without impairment of persons’ health and safety:
Assemble the device in balance on the installation location in order to ensure safe operation. Observe the information on the fastening
holes given in the dimensional drawing. When selecting the set-up location, please mind that the device should be protected against
ambient and mechanic influences. Unhindered access, e.g. for changing the cartridge, must be ensured.
Special measures concerning noise prevention or oscillation reduction do not have to be taken.
To Next Page
Loading...
