BEKA ZEPTO - Operational Mode of Pulse-Dependent Lubrication Duration P3

-43- © BEKA 2019 All rights reserved!
BAL_ZEPTO_1019DE_EN.docx
11.4.3 Operational mode of pulse-dependent lubrication duration P3
In program P3, the lubrication duration is determined by the number of the incoming pulses of a sensor (e.g. proximity switch on a
progressive distributor). If the control does not receive a pulse signal within the monitoring time (12 minutes), it shows the error E5 in
the display and the device signals a malfunction (see chapter 15.1 “Signal displays of the control“).
After eliminating the cause of error, the error must be reset as described in chapter 15.2 “Resetting the error E5”.
The sensor is connected to the bushing M12x1.
Setting:
Hold down the left control key until the
current setting appears in the left
segment of the display, e.g. “1”
Press the left control key as often as
required until the desired setting is
reached.
The control saves the setting automatically;
no further confirmation is necessary.
Display
1
2
3
4
5
6
7
8
9
Lubrication duration (pulse[s])
1
2
3
4
5
6
7
8
9
If program P3 is selected, a sensor must be connected, otherwise the device displays the error E5 after
12 minutes and signals a malfunction (see chapter 15.1 “Signal displays of the control“).
incoming
pulse signals
Time-dependent
cycle duration
Pulse-dependent
lubrication duration
Notice!