Remote Control 13
English
Remote Control
Below is the function description for each button on your remote control.
1. POWER
Press this button to power on the display. Press it
again to put the display into standby mode.
2. INFO
Press this button to display the TV channel message
and any other signal messages (including video or
computer signals). Press the EXIT button (17) to
turn the information off.
3. ASPECT
Press this button to adjust screen image aspect ratio.
4. TV/CATV
Press this button to switch between TV or cable
tuner mode.
5. BACKLIGHT
Press this button to select the desired backlight
level.
6. PIP/PBP
Press this button to simultaneously view signals
from two different sources on the screen.You may
choose picture-in-picture (PIP) mode or picture-
by-picture (PBP) mode.
7. FREEZE
Press this button to freeze the screen (the signal will
continue to be broadcast). Press the button again to
release.
8. SLEEP
Press this button to set the automatic shut-off timer.
9. PRESET
Press this button to select a picture mode.
10. PIP AUDIO
Press this button to select audio for the sub-picture/
main picture or left/right picture when the display
is showing the PIP or PBP screen.
11. CH +/- (add/erase)
Press this button to add the current TV channel to
the sequential channel selection set. Press this but-
ton again to erase the current TV channel from the
sequential channel set.
12. "i" button
Press this button to let the display automatically
adjust frequency, phase and image position in PC or
HDTV modes, or search for signal source and
properly display the video format in the video
mode.
INFO
ASPECT
PIP/PBP
PIP AUDIO
CH+/-
SLEEP
FREEZE
BACKLIGHT
PRESET
PENTER
MUTE
MTS
RTN
CH
VOL
POWER
DV3250-En.book Page 13 Monday, December 13, 2004 12:19 PM
To Next Page
Loading...
Need help?
General
