26
Remote control effective range
The projector has one IR remote control sensor located at the front of the
projector with a range of 8 meters (~26 feet) at an angle of 30 degrees (left
and right) and 20 degrees (up and down). Prior to remote control pairing
process during the setup wizard (see "Powering on and initial setup" on
page 33), the remote control can only be used either by pointing it
directly at the IR sensor or by reflecting the IR signal off of a wall/screen,
making sure that there are no obstacles between the remote control and
the IR sensor on the projector.
Once the remote control has been paired to the projector, you will be able
to use it at any angle within a range of 8 meters (~26 feet).
Note
Voice search functionality on the remote control is only available after the remote control has been
paired to the projector. See "Powering on and initial setup" on page 33 for more details.
Setting to power on projector by remote
control
Powering on the projector via the remote control is not enabled by default.
To enable it, press the
> All settings > Projector > Advanced Settings >
Remote Control > Use remote control to power on.
Once enabled, the projector scans for remote control signals when it is
powered off and may drain battery power gradually.
To Next Page
Loading...
