34
Note
• When supplying power directly to the projector via the supplied power adapter please use the
• Prior to pairing the remote control to your projector you must ensure that your remote control is
in range of the projector’s IR sensor. See "Remote control effective range" on page 26 for more
details.
• Powering on via the remote control is not enabled by default. To enable it, go to
> All settings >
Projector > Advanced Settings > Remote Control > Use remote control to power on.
• Powering on via the remote control will not work if you have not completed the setup wizard pro-
cedure or if the projector’s battery level is below 5%.
4. Follow the on-screen instructions to complete the initial setup. When
you're promted to set up TV, select Set up Google TV as this brings you
complete Google TV enjoyment.
5. In next step, select Set up on TV instead on the lower part of the
screen to access Google TV quickly.
6. Check if an updated firmware is available for your product. Refer to
"Upgrading your projector" on page 38.
7. Go for a preferred scenario.
• "Watching streaming videos" on page 47
• "Projection" on page 53
• "Playing music with your projector" on page 57
Power LED indicator
Scenario LED status Power status
Turning on/off
Flashing white Turning on/off properly
Flashing red Low battery (below 5%)
Charging with adapter
• Power on: Solid
• Networked standby/
Audio only: Breathing
Solid/breathing
green
Fully charged
Solid/breathing
red
Charging
Battery mode
• Power on: Solid
• Networked standby/
Audio only: Breathing
Solid/breathing
green
Battery capacity: 60% -
100%
Solid/breathing
orange
Battery capacity: 21% - 59%
Solid/breathing
red
Battery capacity: < 20%
To Next Page
Loading...
