68
Troubleshooting
The LED indicator is flashing.
Scenario LED status
Driver board error
Flashing red/blue
Fan error
Flashing blue/green
Optical engine temperature error
Flashing red
TOF error
Flashing red/green
Battery malfunction
Flashing purple
G sensor Error
Flashing red/blue/green
Contact customer service for assistance.
Note
Refer to "Power LED indicator" on page 34 for power LED indicator details.
The projector does not turn on.
Possible cause Remedy
There is no power from
the power cord.
Plug the power cord into the AC power jack on
the projector, and plug the power cord into the
power outlet. If the power outlet has a switch,
make sure that it is switched on.
Attempting to turn
the projector on again
during the cooling
process.
Wait until the cooling down process has
completed.
No picture.
Possible cause Remedy
The video source is not
turned on or connected
correctly.
• Check if the video source is properly
connected.
• The projector may be in Audio-only or
networked standby mode. Press the power
key to disable.
To Next Page
Loading...
