BestCode Next Series 8 Technical Manual October 2022 Page 88 of 290
8. Install the new filter. Tighten the
compression nuts hand tight, and
then turn an additional 2 times
with the 5/8” wrench.
See here for charts on selecting
the correct kit for your machine.
9. Align the SmartFilter label into
the SmartFilter reader, and
secure the filter strap.
10. Power on the machine and
navigate to the SmartFill screen
11. Press Read SmartFilter Label
12. Confirm on the Status screen that
the new filter was installed
correctly.
13. Start the Jet and check for leaks.
To Next Page
Loading...
