EasyManua.ls Logo

BestCode NExT 88SHS - System Setup and Configuration; Controller Mounting

Default Icon
305 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BestCode Next Series 8 Technical Manual October 2022 Page 11 of 290
System Setup
The following steps are included to ensure that the Next Series 8 is configured correctly.
Controller Mounting
This section is intended to discuss controller mounting methods.
Controller Mounting Safety
WARNING
PERSONAL INJURY & EQUIPMENT DAMAGE: Do not use any power cord that is not provided by
BestCode. Power cords must have 3 prongs, live, neutral, and ground provided. Power socket-outlet
must provide reliable earth ground. Power cord and outlet must remain clean and dry. The socket-
outlet shall be installed near the equipment and shall be easily accessible. Do not use extension cords!
Follow all local safety regulations during installation and operation of the Next Series 8 CIJ.
WARNING
PERSONAL INJURY & EQUIPMENT DAMAGE: Do not operate the printer without earth grounding.
Failure to provide an earth ground will lead to shock. This may cause serious injury or death to the
operator and will also cause catastrophic damage to the electronic components.
Never print into an ungrounded container. This may cause serious injury or death to the operator and
will also cause catastrophic damage to the electronic components. Some fluids are flammable,
electrical shocks are a serious fire hazard.
WARNING
PERSONAL INJURY & EQUIPMENT DAMAGE: The resistance between equipment Cabinet or Printhead
and the factory earth ground should measure between 0 and 1 ohm. If that value is greater than 1
ohm, a dedicated earth ground may be required. This test should be regularly performed to ensure the
quality and reliability of the electronic circuitry.
WARNING
PERSONAL INJURY & EQUIPMENT DAMAGE: Ink and Makeup produce vapor that is high flammable.
Ensure that adequate ventilation is provided for the Printer. Failure to provide adequate ventilation
may cause high volumes of vapor to accumulate around or inside the printer. These high levels of
fumes are easily ignited, and also have negative health effects. This may cause serious damage to the
Printer and can potentially cause serious injury or death. See SDS for proper vapor handling
instructions.
BESTCODE SAFETY DATA SHEETS:
https://support.bestcode.co/safety-data-sheets/

Table of Contents

Related product manuals