BestCode Next Series 8 Technical Manual October 2022 Page 12 of 290
PERSONAL INJURY & EQUIPMENT DAMAGE: When connected to Supply Power, this Printer produces
Lethal Voltages. Only BestCode trained individuals should service or maintain the Printer. Follow all
local safety codes and regulations. Unless necessary, always disconnect the Printer from Supply Power
when performing maintenance. Unless necessary, never operate the Printer while the Electronics
Compartment door is open. Failure to observe these warnings may result in severe injury or death.
PERSONAL INJURY & EQUIPMENT DAMAGE: Make sure that the Supply Power is within the acceptable
ranges for operating the Printer. These ranges are clearly marked on the side of the Printer.
100-240Vac @240V, 50hz – 22.5V Amps (.225 watts)
50-60Hz @ 120V, 60hz – 45V Amps (.45 watts)
3A MAX
Ideal Controller Mounting
1. Follow instructions included with
40-0019-01 Controller Stand.
2. Plug the attached power cord
into the power socket.
The socket-outlet shall be installed
near the equipment and shall be easily
accessible.
Assembly instructions are included in this video: https://youtu.be/ne0GSWwQg0o
To Next Page
Loading...
