BestCode NExT 88SHS - Page 131

BestCode Next Series 8 Technical Manual October 2022 Page 117 of 290
4. Remove the 7 M4 screws that secure the
circuit board.
Disconnect all cables before
removing the screws.
Removing cables when board
is loose can flex and damage
the board.
5. Immediately place the circuit board into
an anti-static plastic bag and place into a
static-safe carton.
Static safe cartons are included with each
spare Circuit Board. Do not discard them!
6. Install the New Circuit board by aligning
the board onto the plastic standoffs.