EasyManua.ls Logo

BestCode NExT 88SHS - Page 194

Default Icon
305 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BestCode Next Series 8 Technical Manual October 2022 Page 180 of 290
Prompt Code
Prompt Name
Prompt Description
11-8009
Makeup Fault
"SmartFill makeup label required."
Solution 1:
Check Makeup Tank level. Add SmartFill fluid if needed.
Solution 2:
If Makeup Tank Level is high, Inspect Orange tube from makeup tank for clogs, check the valve also to
ensure Makeup is able to flow from Makeup tank into the Ink tank. Scan in a SmartFill label.
Solution 3:
Replace Venturi. Scan in a SmartFill label.
Prompt Code
Prompt Name
Prompt Description
11-800A
Makeup Fault
"SmartFill makeup label required."
Solution 1:
See 11-8009, but expect Makeup Tank to be full.
Prompt Code
Prompt Name
Prompt Description
11-800B
Makeup Fault
"SmartFill makeup label required to start jet."
Solution 1:
Same as 11-8009, but occurs when attempting Jet start.
Prompt Code
Prompt Name
Prompt Description
11-800C
Makeup Fault
"SmartFill makeup label required to start jet."
Solution 1:
Same as 11-800A, but occurs when attempting Jet start.
Prompt Code
Prompt Name
Prompt Description
11-800D
Not Used
-
Solution 1:
Load new Firmware
Prompt Code
Prompt Name
Prompt Description
12-0001
Filter
SmartFilter Label Read
Solution 1:
Press OK.
Prompt Code
Prompt Name
Prompt Description
12-0002
Filter
"Filter Life is at maximum."
Solution 1:
A new SmartFilter label has already been scanned. This SmartFilter label attempting to be scanned will
not be consumed. Prevents accidental SmartFilter label destruction.
Prompt Code
Prompt Name
Prompt Description
12-8001
Filter Fault
SmartFilter label not valid for this machine type.
Solution 1:
The Makeup type cannot be used in this model of machine. Check the Commission screen for
acceptable Makeup types.
Prompt Code
Prompt Name
Prompt Description
12-8002
Filter Fault
SmartFilter replacement required to start jet.
Solution 1:
Replace the Ink Filter. See Instructions here.
Solution 2:
If filter has already been replaced, make sure to Scan the SmartFilter label.
Prompt Code
Prompt Name
Prompt Description
12-8003
Filter Fault
SmartFilter replacement required.
Indicates that the filter life is less than 24 hours until exhausted.
Solution 1:
Replace the Ink Filter. See Instructions here.

Table of Contents

Related product manuals