BestCode NExT 88SHS - Page 290

BestCode Next Series 8 Technical Manual October 2022 Page 276 of 290
Speed (Fast, Fasters, Fastest, UltraFast) in AutoEncoding Modes
After setting up the Photo Eye on the line, run a number of products through at the maximum line speed.
Scenario 1: Actual Print Speed Exceeds Max
Print Speed
Example
Speed: Fast
Max Print Speed: 1300 Rasters / s
Actual Print Speed: 2406 Rasters / s
1. Increase the Speed until the Actual Print
Speed is less than the Max Print Speed
Example
Speed: Fastest
Max Print Speed: 2708 Rasters / s
Actual Print Speed: 2614 Rasters / s
If the speed greatly exceeds the UltraFast Max Print speed, the Font must be changed to a small height font for faster
speeds.
If the Actual Print Speed slightly exceeds the Max Print Speed, try reducing the Print Resolution by 5 to increase the
print length and reduce the Actual Print speed.
Scenario 2: Actual Print Speed is less than Max Print Speed
Setup is OK. Ready to run product.