KBW (E6) 11/2016 page 24/147
5. Functional overview of the MB2 chamber controller
The MB2 chamber controller controls following parameters inside the chamber: temperature (closed loop
control), and fan speed. Illumination is controlled via the operation lines.
You can enter the desired set point values in fixed value operation mode directly on the display surface or
via the setpoint menu. For program operation the controller offers programming week and time programs.
In addition there is a timer program available (stopwatch function).
The controller offers various notifications and alarm messages with visual and audible indication and re-
mote alarms via e-mail, an event list (trace file) and the graphical display of the measuring values in the in
der chart recorder view. The MB2 program controller permits programming temperature cycles. You can
enter values or programs directly at the controller or use the APT-COM™ 3 DataControlSystem software
(option) specially developed by BINDER.
Temperature values
Actual values
Set-point values
Functional icons
Figure 9: Normal display of the MB2 program controller (sample values)
To Next Page
