KBW (E6) 11/2016 page 45/147
9.2 Stopping a running time program
9.2.1 Pausing a running time program
Press the Program pause icon to interrupt the program..
The program is paused. The program runtime stops running down, the time display flashes.
There are the following options:
Press the Program start icon to continue the program
Press the Cancelling icon to cancel the program
9.2.2 Cancelling a running time program
Press the Program cancelling icon to cancel the program.
A confirmation prompt is displayed. Press the Confirm
icon to confirm that the program shall really be can-
celled.
After confirming the message, the controller changes to Fixed value operation mode. The setpoints of
Fixed value operation mode will then equilibrate.
9.3 Performance after the end of the program
After the end of the program the message
“Device changes to fixed value operation
mode” appears on the screen.
Press the Confirm icon.
As long as the message has not been confirmed, the setpoint of the last program section remains effec-
tive. Program the last section as desired. If e.g. heating andrefrigeration shall turn off, activate operation
line “Idle mode” in the last program section.
After confirming the message the controller changes to Fixed value operation mode. The setpoints of
Fixed value operation mode will then equilibrate.
To Next Page
Loading...
