Binder CB Series - Page 4

CB / CB-UL, CBF / CBF-UL (E7) 01/2022 Page 4/199
9.2
Stopping a running time program ...................................................................................................... 81
9.2.1 Pausing a running time program ............................................................................................. 81
9.2.2 Cancelling a running time program ......................................................................................... 81
9.3 Performance after the end of the program ........................................................................................ 81
9.4 Creating a new time program ............................................................................................................ 82
9.5 Program editor: program management ............................................................................................. 82
9.5.1 Deleting a time program.......................................................................................................... 83
9.6 Section editor: section management ................................................................................................. 84
9.6.1 Add a new program section .................................................................................................... 85
9.6.2 Copy and insert or replace a program section ........................................................................ 85
9.6.3 Deleting a program section ..................................................................................................... 86
9.7 Value entry for a program section ..................................................................................................... 87
9.7.1 Section duration ...................................................................................................................... 87
9.7.2 Set-point ramp and set-point step ........................................................................................... 88
9.7.3 Special controller functions via operation lines ....................................................................... 90
9.7.4 Setpoint entry .......................................................................................................................... 91
9.7.5 Tolerance range ...................................................................................................................... 91
9.7.6 Repeating one or several sections within a time program ...................................................... 92
9.7.7 Saving the time program ......................................................................................................... 93
10. WEEK PROGRAMS ............................................................................................. 93
10.1 Starting an existing week program .................................................................................................... 93
10.2 Cancelling a running week program ................................................................................................. 94
10.3 Creating a new week program .......................................................................................................... 94
10.4 Program editor: program management ............................................................................................. 95
10.4.1 Deleting a week program ........................................................................................................ 96
10.5 Section editor: section management ................................................................................................. 97
10.5.1 Add a new program section .................................................................................................... 98
10.5.2 Copy and insert or replace a program section ........................................................................ 98
10.5.3 Deleting a program section ..................................................................................................... 99
10.6 Value entry for a program section ..................................................................................................... 99
10.6.1 Set-point ramp and set-point step modes ............................................................................... 99
10.6.2 Weekday ............................................................................................................................... 100
10.6.3 Start time ............................................................................................................................... 100
10.6.4 Setpoint entry ........................................................................................................................ 101
10.6.5 Special controller functions via operation lines ..................................................................... 101
11. NOTIFICATION AND ALARM FUNCTIONS ...................................................... 102
11.1 Notification and alarm messages overview ..................................................................................... 102
11.1.1 Notifications .......................................................................................................................... 102
11.1.2 Alarm messages ................................................................................................................... 103
11.2 State of alarm .................................................................................................................................. 105
11.3 Resetting an alarm, list of active alarms ......................................................................................... 105
11.4 Activating / deactivating the audible alarm (alarm buzzer) ............................................................. 106
11.5 Tolerance range settings and alarm delay times ............................................................................ 106
11.6 Zero-voltage relay alarm output ...................................................................................................... 108
12. TEMPERATURE SAFETY DEVICES ................................................................. 109
12.1 Over temperature protective device (class 1) ................................................................................. 109
12.2 Overtemperature safety controller class 3.1 ................................................................................... 109
12.2.1 Safety controller modes ........................................................................................................ 110
12.2.2 Setting the safety controller .................................................................................................. 110
12.2.3 Message and measures in the state of alarm ....................................................................... 111
12.2.4 Function check ...................................................................................................................... 111
13. USER MANAGEMENT ....................................................................................... 112
13.1 Authorization levels and password protection................................................................................. 112
13.2 Log in ............................................................................................................................................... 115
13.3 Log out ............................................................................................................................................ 116