When using alternate trigger, the triggered
signal comes from two vertical channels. In
this mode, you can observe two irrelative
signals at a time.
Set trigger type information for CH1 signal
Set trigger type information for CH2 signal
Set trigger type of vertical channel signal to
edge
Go to the second page of the TRIGGER
Menu.
Table 3.24 – Alternate Trigger Edge Mode Function Menu 2
Triggering on rising edge.
Triggering on falling edge.
Triggering on rising edge and falling edge.
Enter “Trigger setup menu” (See Table
3.16).
Go to the back to the first page of the
TRIGGER Menu.
Table 3.25 – Alternate Trigger Pulse Mode Function Menu 1
The trigger signal comes from two
vertical channels when you use
alternative trigger. In this mode, you
can observe two irrelative signals at the
same time.
To Next Page
Loading...
