258
1. 8 7 7. 8 7 7. 2 26 9 BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.87 7.2269
# config -s config.ports.port5.ssh=on
# config -s config.ports.port5.tcp=on
# config -d config.ports.port5.telnet
# config -d config.ports.port5.unauthtel
DEVICE MODE
For a device mode port, set the port type to either ups, rpc, or enviro:
# config -s config.ports.port5.device.type=[ups | rpc | enviro]
For port 5 as a UPS port:
# config -s config.ports.port5.mode=reserved
For port 5 as an RPC port:
# config -s config.ports.port5.mode=powerman
For port 5 as an Environmental port:
# config -s config.ports.port5.mode=reserved
SDT MODE
To enable access over SSH to a host connected to serial port 5:
# config -s config.ports.port5.mode=sdt
# config -s config.ports.port5.sdt.ssh=on
To configure a username and password when accessing this port with Username = user1 and Password = secret:
# config -s config.ports.port#.sdt.username=user1
# config -s config.ports.port#.sdt.password=secret
TERMINAL SERVER MODE
Enable a TTY login for a local terminal attached to serial port 5:
# config -s config.ports.port5.mode=terminal
# config -s config.ports.port5.terminal=\
[vt220 | vt102 | vt100 | linux | ansi]
The default terminal is vt220.
SERIAL BRIDGE MODE
Create a network connection to a remote serial port via RFC-2217 on port 5:
# config -s config.ports.port5.mode=bridge
Optional configurations for the network address of RFC-2217 server of 192.168.3.3 and TCP port used by the RFC-2217 service =
2500:
# config -s config.ports.port5.bridge.address=192.168.3.3
# config -s config.ports.port5.bridge.port=2500
CHAPTER 15: CONFIGURATION FROM THE COMMAND LINE
To Next Page
Loading...
