280
1. 8 7 7. 8 7 7. 2 26 9 BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.87 7.2269
CHAPTER 15: CONFIGURATION FROM THE COMMAND LINE
Run the following commands:
# config -s config.services.http.enabled=on
# config -d config.services.https.enabled
# config -d config.services.telnet.enabled
# config -s config.services.ssh.enabled=on
# config -d config.services.snmp.enabled
# config -d config.services.pingreply.enabled
# config -s config.services.tftp.enabled=on
These services run on default port numbers as follows:
TABLE 15-18. DEFAULT PORT NUMBERS
SERVICE DEFAULT PORT NUMBER
Telnet 2000
SSH 3000
TCP 4000
RFC2217 5000
unauthtel (Unauthorized Telnet) 6000
To set secondary port ranges for any service the following syntax applies:
# config -s config.services.<service>.portbase=<number>
For example: to set all these services to run on a port number that is ten higher than their default, run the following commands:
# config -s config.services.telnet.portbase=2010
# config -s config.services.ssh.portbase=3010
# config -s config.services.tcp.portbase=4010
# config -s config.services.rfc2217.portbase=5010
# config -s config.services.unauthtel.portbase=6010
The following command will synchronize the live system with the new configuration:
# config -r auth
To Next Page