To Next Page

To Previous Page

Use the rotary knob or the view buttons on

Blackmagic MultiView 16’s control panel to

assign values to your network settings.

Changing Settings using

TeranexMiniSmart Panel

The Teranex Mini Smart Panel mounts to the front of your Blackmagic MultiView 4 and replaces

the original basic panel. You get fast access to your settings using buttons, a rotary knob and

built in LCD.

Installing Teranex Mini Smart Panel

Installing your optional Smart Panel is easy and because the panels are hot swappable you

don’t even need to turn off your Blackmagic MultiView 4 when installing it.

1 Remove the two M3 screws on each side of your Blackmagic MultiView 4’s basic front

panel using a Pozidriv 2 screwdriver and gently pull the panel away from the front

of the unit.

2 Remove and retain the light tube connecting the LED to the indicator at the bottom of

the basic panel. This tube is necessary to illuminate the built in status indicator when

the Smart Panel is not installed.

3 Align the connector on the rear of the Smart Panel with the adjoining connector on the

face of your Blackmagic MultiView 4 and gently push the Smart Panel towards the unit

until the connectors are firmly seated. The Smart Panel should make a firm connection

and fit neatly inside the face of your Blackmagic MultiView 4.

4 Re-insert the M3 screws from the original panel.

If your Blackmagic MultiView 4 is installed in a Teranex Mini Rack Shelf, you will need to remove

the unit from the rack shelf to access the front panel screws.

See the ‘Rack Installation’ section for more information.

Your Blackmagic MultiView 4’s USB port is still accessible with the Smart Panel attached.

Toaccess the port, simply open the rubber USB dust cover. With the Smart Panel installed, the

front panel small switches are covered up and no longer used and this is because all the switch

settings are now in the menu on the Teranex Smart Panel and can be set using the LCD.

TIP The original basic panel is very strong, so if you need to mount

yourBlackmagic MultiView 4 in the back of a rack system or in areas where

there are lots of cables or activity, you can always reinstall the original

basic panel.

1515Changing Settings using TeranexMiniSmart Panel

Blackmagicdesign Blackmagic MultiView 4 User Manual

Questions and Answers: