Monitor Settings 1
The first page of the monitor tab contains identical settings for each output. For example, you
can set ‘zebra’ on for the LCD touchscreen, but off for the HDMI output.
Clean Feed
Tap the ‘clean feed’ switch to disable all status text and overlays for an output, except the
record tally indicator.
Your camera will display a record tally even in clean feed mode
Display 3D LUT
Blackmagic Cinema Camera 6K can apply 3D LUTs to any output to approximate the look of
color graded footage. This is especially useful when recording clips using ‘film’ dynamic range.
If your camera has a 3D LUT active, use this setting to independently apply that LUT to your
LCD touchscreen, HDMI output or viewfinder. For more information on loading and using 3D
LUTs, see the ‘3D LUT’ section of this manual.
Zebra
Tap the ‘zebra’ switch to enable zebra guides. For more information on zebra guides and setting
zebra levels, see the ‘touchscreen features’ section in this manual.
Focus Assist
Tap the ‘focus assist’ switch to enable the focus assist overlay. For more information on focus
assist and setting focus assist levels, see the ‘touchscreen features’ section in this manual.
NOTE box deleted
NOTE box deleted
59Settings
To Next Page
Loading...
