Section Aa.13
•
THE
ENGINE
(3)
Remove the converter, converter housing, and the
transmission unit from the engine as detailed in
Section AaA.
CONVERTER OUTPUT GEAR
Aa
•
Refitting
(4)
Refitting
is
a reversal
of
the removing procedure
(see
Sections A.24 and Aa.3-4).
Section Aa.11
CRANKSHAFT AND MAIN BEARINGS
Removing
(1) Follow the instructions given in Section A.25 with
the following exceptions.
(2)
Remove the engine and transmission unit as
detailed in Section Aa.3.
(3)
Remove the converter, converter housing, and the
transmission unit from the engine as detailed in
Section AaA.
Refitting
(4)
Follow the refitting instructions for installation
of
the crankshaft and bearings given in Section A.25
(5) Carry out the inspection and refitting
of
the trans-
mission unit as detailed in Section AaA.
Removing
(I) Remove the engine and transmission as detailed
in Section Aa.3.
(2)
Carry out the removing instructions as detailed in
Section AaA, items (3) to
(11)
and (13).
Adjusting
(3)
Carry out the instruction given in Section AaA,
item
(22).
Refitting
(4)
Refitting
is
a reversal
of
the removal procedure.
Section Aa.14
CYLINDER LINERS
Follow the instructions in Section A.24 with the
following exceptions.
(1)
Remove the engine and transmission from the car
as detailed in Section Aa.3.
(2)
Remove the transmission unit from the engine as
detailed in Section AaA.
Section Aa.1S
Section Aa.12
ENGINE MOUNTINGS
Removing
Left-hand mounting
(1)
Follow the instructions in Section A.14.
• Right-hand mounting
(2)
Disconnect the battery earth cable.
(3)
Disconnect the electrical connections from the
starter solenoid and remove it from the wing
valance.
(4)
Disconnect the engine tie-rod from the rear
of
the
cylinder block and the exhaust down pipe from
the manifold flange.
(5)
Remove the two nuts and set screws securing the
mounting to the sub-frame.
(6)
Lift the rear
of
the engine sufficiently to remove the
securing nuts and bolts from the converter cover
and the starter motor. Turn the cover slightly
anti-clockwise and remove the cover complete
with the engine mounting.
(7)
Unscrew the set screws to release the mounting
from the cover.
•
Refitting
(8)
Refitting is a reversal
of
the removal procedure.
MINI. Issue
2.
16208
CONVERTER HOUSING OIL SEAL
REPLACEMENT
Removing
(1) Remove the engine from the car as detailed in
Section Aa.3.
(2)
Remove the starter motor and converter cover.
Fig.
Aa.21
.~
A section through
of
fitting the converter housing
oil seal.
A = the depth measurement to be taken
1.
Convertor housing.
3.
Service tool
180
1068.
2. Oil seal.
4.
Service tool adaptor
set
180
1068A.
Aa.II
mk1-performance-conversions.co.uk
To Next Page
Loading...
