www.bodor.com/service@bodor
.com
2.5 Operation environment
The machine is limited to be used in the following environments!
Operations beyond the environments may bring greater risks or affect the
machine's function and performance.
Indoor use. Note: Avoid thermal deformation caused by direct sunlight on one side or wind on one side (for example, blinds
can be installed when installing in the window position to avoid these situations).
Ambient temperature: 5℃～40℃。（For very hot and cold environments, additional requirements are required）.
Relative air humidity: ≤70%.
Atmospheric pressure: 86KPa～106KPa.
Vibration isolation, no corrosive medium, no strong magnetic field interference, dust degree ≤ 2mg/m
3
.
It is recommended that capable users provide a constant temperature and humidity environment for the equipment.
No conductive dust and corrosive gases that damage insulation.
No vibration, shock and radiation affect the machine. When there are electric welding and electric discharge machines
nearby, the equipment must be powered off and cannot continue to work, otherwise Bodor Laser will not be liable.
No potential flammable and/or explosive environment.
Make sure that there are no particles or substances that can absorb rays with a wavelength of 1.064μm around the machine.
For example, solvent-containing steam emitted during painting, or steam emitted from degreasing equipment.
Avoid the water cooler environment close to the dew point to avoid equipment damage.
The dew point temperature refers to the temperature at which the air is cooled to saturation without changing the water
vapor content and air pressure. To put it vividly, the temperature at which the water vapor in the air turns into dew is called
the dew point temperature, as shown in Table 2-1.
To Next Page
Loading...
