www.bodor.com/service@bodor
.com
2.4 Hoisting Position and Forklifting Point of the Lathe Bed
I5 Bare crane is only allowed to be loaded and transferred by fork, lifting is not allowed, and the forklift can only be
transported from the side. The forklift area is about 1250mm. It is necessary to effectively avoid the trolley guide rail (about
250mm wide). The forklift point position is relatively centered with the equipment, and the fork tooth length meets the
equipment requirements. The following view is only for reference.
For detailed unloading steps, please refer to the operation instruction for equipment on site positioning and the
operation instruction for equipment on site installation. Please unload according to our requirements, otherwise our
company will not be responsible for any situation.
2.5 Storage Conditions, Period and Notes
The ambient temperature of the plant where the laser cutting machine is stored should be -10℃~40℃ with the relative
humidity of 45%~85%. In the plant, different kinds of harmful gases, flammable and explosive products and corrosive
chemicals are not permitted. The cooling water in the equipment must be drained without strong mechanical vibration,
shock and strong magnetic field interference. The host equipment and packing box should be at least 100mm away from the
ground. Outdoor storage is strictly prohibited. The storage period shall not exceed six months. If it is stored for more than
six months, a full inspection is required. Only after passing the inspection can the equipment be used.
To Next Page
Loading...